![]() ![]() Somehow be able to change the coding where it says about the bap protocol and change it from 4.0 to 3.3, orĢ. So, as far as I am concerned, I think that I need either one of those:ġ. I am almost sure that it is only the matter of changing the BAP protocol version from 4.0 (as it has now) to 3.3 (which was the value at my default module), but I can't code that as VCDS gives me an error 31 (even after I input security code). I know that it is most probably because the module has a firmware inteded for mib std2 unit (which I will install in the future). ![]() ![]() I replaced my default module and it works - it beeps and it parks on its own, but no ops360 displays on my RNS315 unit. I own a Superb II 2015 which had PLA from the factory, but I wanted to replace the PLA module (3t0 919 475 F) for the one that activates itself when slowly approaching to the obstacle, so I bought a 1K8 919 475 D at the aftermarket. I have been looking all over the net to get help about that, you are my last hope. ![]() I can't select this address any more.Hi, Elect.īut If I select address 46: Central Conv., I got several times an error "No response from controller".Īnd then I made auto-scan again and now I don't have address 46 on the list. I solve problem to connect to addreess 09 so, that I turned off the car, then I locked the car and unlocked again and then I could connect to address 09: Cent. I select auto scan function and I got this result: Today I tried to connect to the car computer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |